-
PLN -
EUR
PLN EUR 
An innovative, nanotechnology product for colorless protection of most types of concrete surfaces. The product effectively impregnates and strongly hydrophobicizes surfaces such as concrete haberdashery, curbs, concrete slabs, pipe palisades, etc.
An innovative, nanotechnology product for colorless protection of most types of concrete surfaces. The preparation effectively impregnates and strongly hydrophobicizes surfaces such as concrete fancy goods, curbs, concrete slabs, pipe palisades, etc.. Thanks to the impregnation, water and other contaminants do not penetrate the interior of concrete surfaces. Surface hydrophobization also prevents the penetration of salts transported by water, acid rain, or other substances that have a negative impact on concrete, causing reinforcement corrosion, cracks, erosion, moss growth, salt efflorescence, or just dirt.
Hydrophobization also affects the strength of concrete and increases its frost resistance. In the autumn and winter, frost makes concrete more vulnerable to freezing of moisture, which causes internal stresses and micro-cracks, and consequently its chipping.
The impregnation, depending on the amount of used preparation, penetrates up to several mm, which guarantees resistance to mechanical abrasion, which allows it to be used both on walls and on floors or parking lots.
The use of nanoparticles guarantees the unchanged vapor permeability after impregnation, the product does not clog pores, does not lubricate and does not limit gas diffusion and water vapor removal.
Application:
concrete haberdashery, curbs, concrete slabs, pipe palisades
Efficiency:
7 – 10 m2 per liter
Instruction:
It is recommended to use protective glasses and gloves.
Plan the impregnation so that after its completion it does not rain for at least 3 hours. At the beginning, always test in an inconspicuous place and check if the effect is desired!
Protect plants and all other surfaces not to be impregnated with foil, especially glass and steel. In case of contamination, clean these surfaces immediately with a wet cloth or rinse with water. The surface prepared for impregnation must be clean and dry.
It is best to apply the appropriate amount of the preparation on the surface by spraying, but so that the impregnation does not create streaks - apply only as much impregnation as the concrete is able to absorb, the excess should be spread with a brush or removed with a cloth. Leave to dry. ATTENTION! Apply one or two coats but only wet on wet. Tools should be rinsed with running water.
Features:
Application methodsi:
garden sprayer, HVLP gun
How to use:
It is recommended to use protective glasses and gloves.
Plan the impregnation so that after its completion it does not rain for at least 3 hours. At the beginning, always test in an inconspicuous place and check if the effect is desired!
Protect plants and all other surfaces not to be impregnated with foil, especially glass and steel. In case of contamination, clean these surfaces immediately with a wet cloth or rinse with water. The surface prepared for impregnation must be clean and dry.
It is best to apply the appropriate amount of the preparation on the surface by spraying, but so that the impregnation does not create streaks - apply only as much impregnation as the concrete is able to absorb, the excess should be spread with a brush or removed with a cloth. Leave to dry. ATTENTION! Apply one or two coats but only wet on wet. Tools should be rinsed with running water.
