Specialchem ​​CONCRETE PANEL hydrophobic impregnation for concrete fences

Specialchem ​​CONCRETE PANEL hydrophobic impregnation for concrete fences

Innovative, nanotechnology product for colorless protection of fences, palisades and concrete panels. The preparation effectively impregnates and strongly hydrophobicizes concrete surfaces. Thanks to the impregnation, water and other impurities do not penetrate the surface. Surface hydrophobization also prevents the penetration of salts transported by water, acid rain, or other substances that have a negative impact on concrete, causing reinforcement corrosion, cracks, erosion, moss growth, salt efflorescence, or just dirt.

Hydrophobization also affects the strength of concrete and increases its frost resistance. In autumn and winter, frost causes that concrete is more exposed to freezing of moisture causing internal stresses and micro-cracks, and consequently its chipping.

The impregnation, depending on the amount of used preparation, penetrates up to several mm, which guarantees long-term protection, aesthetics and cleanliness of the fence.

Durability: about 5 years.

Efficiency: 10 to 15 m2 from 1 liter

Application:

• concrete fence panels
• concrete palisades
• concrete walls and pillars

Application methods:

garden sprayer, HVLP gun

Features:

• Easy and safe to use
• One layer should be used
• Penetration up to 10 mm
• Does not change the appearance of the substrate
• Resistance to UV, chemistry, low and high temperatures

How to use:

It is recommended to use protective glasses and gloves.

Plan the impregnation so that after its completion it does not rain for at least 3 hours. At the beginning, always test in an inconspicuous place and check if the effect is desired!

Protect plants and all other surfaces not to be impregnated with foil, especially glass and steel. In case of contamination, clean these surfaces immediately with a wet cloth or rinse with water. The surface prepared for impregnation must be clean and dry.

It is best to apply the appropriate amount of the preparation on the surface by spraying, but so that the impregnation does not create streaks - apply only as much impregnation as the concrete is able to absorb, the excess should be spread with a brush or removed with a cloth. Leave to dry. ATTENTION! Apply one or two coats but only wet on wet. Tools should be rinsed with running water.

see other products for construction: kliknij

We recommend our blog with tips: kliknij