A high-quality impregnation based on nanotechnology protects the surface of natural stone against the effects of: erosion, water, salt, moss growth, mold and contamination.
Thanks to the penetration into the stone, the impregnation is resistant to use on floors and parking lots. Nanoparticles included in the impregnation penetrate deep into the surface, guaranteeing long-term effective protection.
A high-quality impregnation based on nanotechnology protects the surface of natural stone against the effects of: erosion, water, salt, moss growth, mold and contamination.
Thanks to the penetration into the stone, the impregnation is resistant to use on floors and parking lots. Nanoparticles included in the impregnation penetrate deep into the surface, guaranteeing long-term effective protection.
The preparation is a water solution, therefore it is perfect for surfaces inside and outside buildings - it does not leave unpleasant odors. It does not contain toxic solvents.
The impregnation does not clog the pores, which means that it does not limit the vapour-permeability of the stone after impregnation.
In the period around winter, thanks to effective deep penetration, it increases the frost resistance of the stone. Used on terraces and balconies, it blocks the penetration of moisture and the stone falling off the ground.
Application:
all kinds of natural stone (unpolished), sandstones, limestones, river stones, field stones, split and flamed granites,
Perfect for:
car parks, fences, walls, facades of buildings, sidewalks and footbridges, walls, terraces, balconies, window sills and other types of architectural objects.
Features:
Efficiency:
10–15 m²/1 liter – consumption depends on the application technique and absorbency
Application method:
Best applied by spraying. HVLP gun or garden sprayer.
Instruction:
Caution, do not apply on a very hot surface.
The product is ready to use! Do not dilute with water or other substances.
It is recommended to use protective glasses and gloves.
Plan the impregnation so that after its completion it does not rain for at least 3 hours. At the beginning, always test in an inconspicuous place and check if the effect is desired!
Protect plants and all other surfaces not to be impregnated with foil, especially glass and steel. In case of contamination, clean these surfaces immediately with a wet cloth or rinse with water. The surface prepared for impregnation must be clean and dry.
Before impregnating the entire surface, make a test in an inconspicuous place to check whether the effect is desired.
It is best to apply the appropriate amount of the preparation on the surface by spraying, but not too much, so that the impregnation does not create streaks (only as much impregnation as the surface is able to absorb), the excess should be spread with a brush or removed with a cloth. Leave to dry.
ATTENTION! Apply one or two coats but only wet on wet. Tools should be rinsed with running water.
Safety and storage: Protect from frost. Follow basic health and safety rules. Keep the product tightly closed and out of reach of children and pets. Avoid contact of the preparation with skin and eyes. Before use, it is recommended to read the technical data sheet of the preparation. Store in the temperature range 0-35°C